Makita AN611 Manuel D'instruction page 7

magazine cap and door.
005614
Hook
1
005615
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
CAUTION:
Always lock the trigger and disconnect the hose
•
when hanging the tool using the hook.
Always tighten the hook securing bolt firmly. Loose
•
bolt may cause air leakage from the tool.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
005616
Nails
Nail
004310
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape or
1. Small rod
1
2. Ejection port
2
1. Hook
their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
Humid
Nail
004311
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
005617
Make sure all safety systems are in working order before
operation. The tool must not operate if only the trigger is
pulled or if only the contact element is pressed against
the wood. It must work only when both actions are
performed. Test for possible faulty operation with nails
unloaded.
005618
Make sure that the trigger is locked when the change
lever is set to the LOCK position.
7
Hot