Tonino Lamborghini PC 26 TL Traduction Du Mode D'emploi D'origine page 39

File diameter
Type of chain
91P
91PJ
91VG
E1-
25AP060T
Depth gauge
Guide bar
• Reverse the bar occasionally to prevent partial wear.
• The guide bar should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between them,
the guide bar is normal. Otherwise, the guide bar is
worn. Such a bar needs to be corrected or replaced.
GB | Operating Instructions
Top plate angle
Vise rotate angle
5/32" 30°
5/32" 30°
5/32" 30°
5/32" 30°
Down angle Head tilt angle
(55°)
Vise tilt angle Side angle
0°
0°
0°
10°
File
17
Depth gauge
standard
80° 0,025"
80° 0,025"
80° 0,025"
85° 0,025"
1) Ruler
2) Gap
3) No gap
4) Chain tilts