Maintenance Of Saw Chain And Guide Bar - Tonino Lamborghini PC 26 TL Traduction Du Mode D'emploi D'origine

Spark plug type:: RCJ7Y Champion
4. Sprocket
Check for cracks and for excessive wear interfering with
the chain drive. If the wear is considerable, replace it
with new one. Never fit a new chain on a worn sprocket,
or a worn chain on a new sprocket.
5. Front and Rear dampers
Replace if adhered part is peeled or crack is observed on
the rubber part. Replace if the inside of the rear damper
metal has been beaten by the stopper bolt and the clear-
ance of the metal increased
WARNING
Use only the spare parts which named in this manual.
Use the other spare part can cause serious injury.
11. Maintenance of Saw Chain and Guide
Bar
WARNING
It is very important for smooth and safe operation to keep
the cutters always sharp.
Your cutters need to be sharpened when:
• Sawdust becomes powder-like.
• You need extra force to saw in.
• The cut way does not go straight.
• Vibration increases.
• Fuel consumption increases.
Cutter setting standards:
WARNING
Be sure to wear safety gloves.
Before filing:
• Make sure the saw chain is held securely.
GB | Operating Instructions
• Make sure the engine is stopped.
• Use a round file of proper size for your chain.
Chain type:
PC 26 TL: see table „Guide bar und Saw"
PC 26CA TL: Longer E1-25A P060T
File size: 5/32 in (4.0 mm)
Place your file on the cutter and push straight forward.
Keep the file position as illustrated.
After every cutter has been set, check the depth gauge
and file it to the proper level as illustrated.
Be sure to round off the front edge to reduce the chance
of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as shown below.
16
WARNING