IFM Electronic AC1308 Notice De Montage page 14

O System setup (Setting of the controller
O System info
O PLC setup
O PLC info
O Master setup (AS-i master flags)
14
PAGE
∇ Baud rate of the serial programming interface
∇ IP address of the Ethernet programming interface
(optional)
∇ Input of the password to enable changes in the
system configuration
∇ Update of the controller
gramming software required)
(Device information)
∇ Hardware and firmware version numbers of this
controller
e
∇ Serial number of this controller
∇ Current /maximum PLC cycle time
(Using the integrated PLC is optional)
∇ Activation or deactivation of the gateway mode
(no PLC used)
∇ Start or stop of the PLC in the controller
used)
(Display of the user program name, author, date)
∇ Reading of the current AS-i configuration (config all)
∇ Changeover to the projection mode: configurati-
on of the AS-i system
∇ Changeover to the protected mode: standard
mode (the master monitors the configuration)
∇ Deactivation of the automatic AS-i slave addres-
sing in the protected mode
∇ Deactivation of the AS-i reset when exiting the
projection mode
∇ Display of the config.error counter of the connec-
ted AS-i system
∇ Reset of the config.error counter
∇ Display of the percentage fault rate of the
connected AS-i system
device)
e
firmware (special pro-
e
e
(if
e