General Safety Instructions; Test Symbols; Troubleshooting; Appliance Description - Stiebel Eltron MHG 35 E Utilisation Et Installation

OPERATION

Troubleshooting

2.2

General safety instructions

WARNING Injury
!
- Keep children under the age of 3 away from the
appliance if constant supervision cannot be guar-
anteed.
- Children from the age of 3 to 7 may switch the ap-
pliance on and off, provided they are supervised
or have been instructed in the safe operation of
the appliance and understand any risks that may
result. This is subject to the appliance having been
installed as described.
Children from the age of 3 to 7 must not plug the
power cable into its socket or regulate the appli-
ance.
- The appliance may be used by children aged 8 and
older and persons with reduced physical, sensory
or mental capabilities or a lack of experience and
know-how, provided that they are supervised or
they have been instructed on how to use the appli-
ance safely and have understood the potential risks.
- Children must never play with the appliance. Chil-
dren must never clean the appliance or perform
user maintenance unless they are supervised.
WARNING Injury
!
In closed rooms, temperatures can rapidly reach high
values. Ensure constant supervision if the appliance is
operated in a small room and the persons within that
room cannot regulate the appliance or leave the room
on their own.
WARNING Injury
!
Depending on the size of the natural stone panel, it
may weigh up to 70 kg and could cause serious injury
if dropped.
f Never tilt the appliance. f
WARNING Burns
Do not operate the appliance when work, such as laying
tiles, grinding, sealing, cleaning with naphtha or floor
maintenance (spray, floor polish), is being carried out in
the installation room.
WARNING Burns
Parts of the appliance can get very hot and may cause
burns. Particular caution is advised when children or
vulnerable persons are present.
WARNING Burns
- Never cover the appliance.
- Never place any objects on top of the appliance.
- Do not lean any objects against the appliance.
- Do not place any objects between the appliance and
the wall (e.g. to dry clothes).
- Do not place any flammable, combustible or insulat-
ing objects or materials, such as laundry, blankets,
magazines, containers with floor polish or naphtha,
spray cans or similar, in close proximity to the ap-
pliance.
- Observe minimum clearances (see chapter "Specifi-
cation / Minimum clearances").
14 | MHG, MHJ, MHP, MHS, SPH
WARNING Overheating
In order to avoid overheating, do not cover the heater.
2.3

Test symbols

See type plate on the appliance.
3. Troubleshooting
Problem Cause
The appliance Fuse or safety switch has
does not heat blown/tripped.
up.
Overheating. The high
limit safety cut-out has
tripped.
If you cannot remedy the fault, contact your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
4.

Appliance description

The natural stone heater is an electrically heated marble or soap-
stone panel, which is regulated by means of an external room
temperature controller.
A heating conductor is embedded in the rear of a 30 mm thick
natural stone panel for this purpose, which heats the panel evenly.
Heat stored in the natural stone panel is released in the form of
long wave radiation (comparable with solar rays). Consequently,
occupants and objects alike are heated in the room without any
air turbulence.
Thanks to the use of undercut anchors for attaching the wall
mounting brackets to the natural stone panel, the mounting points
are invisible at the front. This means that the structure of the panel
is uninterrupted. The wall mounting brackets are convertible, so
the natural stone heater can be mounted horizontally or vertically.
Note
Never place objects between the appliance and persons
requiring heating. In this case, the objects would be heat-
ed rather than the persons.
5. Operation
Natural stone heaters are controlled exclusively via external room
temperature controllers.
Observe the operating and installation instructions for the relevant
controller.
6.

Maintenance and care

Clean the natural stone heater with a damp cloth when it has
cooled down. Do not use any abrasive or corrosive cleaning prod-
ucts.
Remedy
Check the respective fuses and
safety switches.
Remove the cause.
Remove the cause. The appliance
restarts after it has cooled down
for a few minutes.
www.stiebel-eltron.com