Panasonic EY75A7 Instructions D'utilisation page 11

[Main Body]
• When storing or carrying the tool, set
the Forward/Reverse lever to the
center position (switch lock).
Exercise caution to ensure no objects
come into contact with the tool's
trigger switch.
Operation [Fig.4]
Push the lever for forward or reverse
rotation. Check the direction of the lever
before using.
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
The belt hook can be attached to either
side of the unit.
• Be sure to attach the belt hook securely
fastened.
• Periodically check screw for tightness.
• When the main unit is held by the belt
hook, avoid jumping or running with it.
• When the unit is hooked onto the waist
belt by the belt hook, do not attach
driver bits to the unit. A sharp edge
object, such as a drill bit, may cause
injury or an accident.
The driver is preset to "Hard" impact mode
setting when shipped from the manufac-
turer.
• Selecting the impact power among 4
modes (Hard, Self-drilling screw, Soft,
Medium).
Press the impact power mode button to
set it. The mode changes to Hard,
Self-drilling screw, Soft or Medium each
time the button is pressed.
• Selecting the impact power among 3
modes (Hard, Soft, Medium).
Press the impact power mode button to
set it. The mode changes to Hard, Soft or
Medium each time the button is pressed.
Hard
- 11 -
EY75A7:
0 – 2500 rpm
and
0 – 3100 i.p.m.
EY75A8:
0 – 2500 rpm
and
0 – 3600 i.p.m.
• Jobs requiring high
torque.
EY75A7:
0 – 1450 rpm
and
0 – 2900 i.p.m.
EY75A8:
0 – 1500 rpm
and
0 – 2900 i.p.m.
• Jobs requiring decent
torque.
EN