H.Koenig AXO900 Manuel D'utilisation page 5

Assembly of metal extension pipe and floor brush
Insert the front end of the hose handle into the metal extension pipe according to Figure (5); then
insert the other end of the metal extension pipe into the rounded inlet of the floor brush, and
adjust to the proper direction. At this time, the assembly of the whole machine is completed.
How to start
1. First of all, pull out the power cord from the cord reel to the needed length; insert the
power cord plug into the power socket, and press down the power switch button with finger
or step on it with foot; then you can control the start and stop of the cleaner.
2. The yellow mark on the power cord indicates its desired length. Never pull out the power
cord to the length exceeding the red mark.
Protective devices of motor
1. There is a temperature controller designed in the body of cleaner motor, which can
automatically cut off the power supply of motor to prevent overheating. When the air-inlet or
air-outlet pipe is overloaded or blocked, the temperature of motor rises, then the temperature
controller cuts off the power supply of motor automatically to make the motor cool, preventing the
cleaner from being damaged.
2. If the temperature controller is cut off, stop the cleaner immediately and pull out the power plug
to make the cleaner cool, and check and remove the hair roll or other roll-like rubbish blocking the
air inlet (including the hose and the spile), and replace the filter HEPA or filter gauze when
necessary.
3. After cooling the motor for 30mins, plug in the power plug and check whether the temperature
controller has been reset. If the power supply of the cleaner hasn't been cut off, the temperature
controller of the motor won't be reset even when the motor has become cool.
Operation Instructions
Figure (5)