Wall Installation - ARDES AR4W08P Mode D'emploi

If you decide you do not want to use this appliance any longer, disable it by cutting
the power cable - of course, after disconnecting it from the socket.
The power cable should be extended to its full lenght to avoid over heating.
For safety reasons, the appliance should never be opened.
The appliance has been designed and manufactured to operate in the home.
Any other use is considered inappropriate and dangerous.
Do not insert objects through the safety grill or the air inlets.
Do not use this heating appliance with programmers, timers, separate remote
control systems (different to the ones provided with the appliance) or any other
device that automatically turns on the appliance, as there is a risk of fire in the
event the appliance is covered or positioned incorrectly.
Do not use the heater in presence of flammable substances (petrol,paints, etc.).
Do not place the cord near sources of heat.
WARNING: DO NOT COVER THIS PRODUCT NEAR CURTAINS OR OTHER
COMBUSTIBLE MATERIAL.
WARNING: DO NOT COVER THE APPLIANCE OR OBSTRUCT THE AIR
INLETS TO AVOID OVERHEATING.
(EN) TECHNICAL INFORMATIONS
1 - Main switch On/Off
2 - Air outlet grid
3 - Control panel and indicator light
4 - Remote control
Technical data indicated on the appliance.
(EN) INSTRUCTIONS FOR USE
ASSEMBLY INSTRUCTIONS
Assembly kit composed of: 2 screws Ø 4 mm - 2 wall plugs Ø 8mm

WALL INSTALLATION

Fix the two plugs to the wall with the respective screws, taking into consideration
that the distance between them must correspond to that between the two hanging
holes on the back of the appliance. Leave the heads of the screws protruding out
from the wall enough so that the appliance can be hung on the screws. Once the
appliance has been hung on the screws, push it to the right so that the screws go
into the guide above the hole, thus improving the stability of the appliance.
The appliance must be installed at least 1,80m above the ground and 15 cm
from the ceiling.
OPERATION.
The appliance can emit both cold and hot air, depending on hot it is set.
Before connecting or disconnetting the appliance, make sure the main switch
On/Off (1) is in Off position (O).
16/90