Jenn-Air JJW9830DDP Guide D'utilisation Et D'entretien page 30

T
ROUBLESHOOTING
PROBLEM
Oven baking results are less
than expected.
Baking results differ from
previous oven.
Fan is heard when oven is
turned on.
Cooling fan continues to
operate after the oven has been
turned off.
Probe does not work.
(select models)
Fault Codes
There are no beeps and
no display.
Noises may be heard.
SOLUTION
• The pans being used may not be of the size or material recommended for best
results. (See "Cooking Made Simple" booklet).
• There may not be sufficient room around sides of the pans for proper air circulation
in the oven.
• Check instructions for preheating, rack position and oven temperature.
• Oven thermostat calibration may differ between old and new ovens. Follow recipe
and use the directions in this guide before calling for service since the calibration on
the previous oven may have drifted to a too high or too low setting. (See page 21 -
Temp Adjust.)
• This is the cooling fan and is normal. The fan will continue to run after use
until the oven cools. (See page 12.)
• This is normal. The fan will automatically shut off when the oven has cooled.
• Check to be sure probe plug is properly inserted into oven receptacle.
• Probe may not be positioned in food properly.
• Probe temperature may have been improperly set.
• Food may have been too cold or frozen when the probe was inserted.
• The oven may detect a fault during programming or during operation. If a fault is
detected, the message "Fault detected - press power to clear" or "Fault detected -
press enter to try again" may appear. Follow directions in the display. If the fault
reappears or does not clear, call an authorized servicer or the toll-free number in the
display.
• If the same operation is attempted before having the wall oven repaired, the message
"Feature not available" will appear. The feature will remain inoperable until service
is obtained.
• If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
• Oven may be in Sabbath Mode. (See page 21.)
• The oven makes several low level noises. You may hear the oven cooling fan going
on and off. You may also hear the oven relays as they go on and off. These are all
normal.
• As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
29