Battery Replacement - TFA CIRCLE-PEN Mode D'emploi

TFA_No. 31.1139_Anleitung
CIRCLE-PEN - Infrared thermometer
6. Distance, Spot Size, and Field of View
• As the distance (D) from the object increases, the spot size
(S) of the area measured by the unit becomes larger at a
ratio D:S = 9:1 (e.g. 90 cm distance = 10 cm spot size). To
get the most accurate temperature reading, aim at the tar-
get as near as possible.
• Should the distance be too great, there is a risk the temper-
ature outside the aimed target has also been taken. The cir-
cular laser helps to aim at the exact area to be measured.
Please take note of the following
• Not suitable for measuring shiny or polished metal surfaces
(stainless steel, aluminium, etc.).
• The unit cannot measure through transparent surfaces such
as glass or plastic. It will measure the surface temperature
of the glass instead.
7. Care and maintenance
• The sensor lens is the most delicate part of the thermome-
ter. Please protect it from dirt.
• Clean your instrument with a soft damp cloth. Do not use
solvents or scouring agents.
• Remove the battery if you do not use the product for a long
period of time.

7.1 Battery replacement

• The battery symbol appears permanently on the display.
Full
• Change the battery when the battery symbol
on the display.
• Make sure the unit is power off before changing the battery.
7. Troubleshooting
Problems
No display
10
01.04.2016 11:36 Uhr
Half-full Empty
appears
Solutions
➜ Switch on the unit – press
and hold the measuring
button
Seite 6
CIRCLE-PEN - Infrared thermometer
Er1
Er2
Er3
Display "Hi/Lo"
If your device fails to work despite these measures contact the
retailer from whom you purchased it.
8. Waste disposal
This product has been manufactured using high-grade materials
and components which can be recycled and reused.
Never dispose of empty batteries and recharge-
able batteries in ordinary household waste.
As a consumer, you are legally required to take
them to your retail store or to an appropriate
collection site depending on national or local
regulations in order to protect the environment.
The symbols for the heavy metals contained are:
Cd=cadmium, Hg=mercury, Pb=lead
This instrument is labelled in accordance with
the EU Waste Electrical and Electronic Equipment
Directive (WEEE).
Please do not dispose of this instrument in
household waste. The consumer is obligated to
take end-of-life devices to a designated collec-
tion point for the disposal of electrical and elec-
tronic equipment, in order to ensure environ-
mentally-compatible disposal.
9. Specifications
Temperature range
Operating temperature/
humidity
Storage temperature/
humidity
➜ Ensure the battery polarity is
correct
➜ Change the battery
➜ Operating environment is
below -10°C or above 50°C
➜ Large temperature changes
in a short time
➜ Remove the battery (confirm
the unit is powered off)
➜ Recommended wait time:
at least 60 seconds
➜ Measured temperature is
outside the measuring range
-33 °C .... + 500 °C
- 27 °F...+932 °F
0 °C ... + 50 °C
32°F...122 °F/ < 90 %rH
10 °C ... + 40 °C
50°F...104 °F /< 65 %rH
11