Toto MS604114 Série Manuel D'installation page 4

4)
ply (not supplied) prior to connection
bucket or similar catch basin until all
not become contaminated. Connect the
tube connector or equivalent (see Ill. 3).
C AUTION: Do not over-tighten the nut
Open the supply stop, checking for leak-
age. Slightly re-tighten if necessary. The
water supply pressure should be 20 to
80 psi static.(Trim Plate, Nipple, Valve &
Flexible Supply - not supplied.)
5) NOTE:
ments are needed. The water will auto-
matically stop at proper level.
Flush the toilet several times. Check
Make sure that chain is not tangled and
6) Install the toilet tank lid onto the toilet
tank top.
7) Install the toilet seat onto the toilet
bowl (see Ill. 4). (Top Mount Bolt Set
is included with the bowl). Insert the
rubber bushing nuts into the bowl seat
holes.
NO TE: Remove the existing seat if
necessary.
Place the seat on the bowl and rotate
the hinge unit into place while hold-
ing seat down on the bowl. Fasten and
tighten the bolt from the top with a
screwdriver. Replace the bolt cap and
the lower lid (if necessary).
INSTALLATION PROCEDURE
-
-
4
Ill. 3
Water Inlet
Washer
Coupling Nut
Trim Plate
Nipple
Ill. 4
Seat Bolt
Hinge
Seat
Stopper
Tank
Flexible Supply
(not supplied)
Valve Nut
Compression
Valve
Seat Bolt Cap
Hinge
Seat
Stopper
Bolt
Bowl
Nut