Before Installation; Installation Procedure - Toto MS604114 Série Manuel D'installation

Masquer les pouces Voir aussi pour MS604114 Série:

Manuel d'installation (12 pages)

Table des Matières

Les langues disponibles

Read these instructions thoroughly before beginning

work. Please leave instructions for customers.

These instruction contain maintenance and warranty

information.

If necessary, remove the existing toilet.

IMPORTANT!

Due to the powerful performance of our Cyclone, G-Max,

E-Max and Power Gravity ushing systems, they are not

speci ed for back-to-back installations. The only means of

installing these toilets in a back-to-back situation is when the

toilet drain connections incorporate a WYE tting. Please

contact your builder or contractor prior to this installation.

In order for your new TOTO toilet to t correctly,

check the dimensions below:

1) Clean any debris out of the closet ange, then install the

mounting bolts into the slots of the ange (see Illustration 1). The

bolt should be inserted into the slot with its head down and

threaded shank pointed upward.

2) Carefully turn the toilet upside down on some padding. Firmly

press a new wax seal (not supplied) onto the circular recess

around the outlet opening (see Ill. 2). Turn the toilet upright and

gently lower it into position over closet ange & bolts. With the

toilet properly aligned, press down rmly on both sides of toilet

rim to seat wax seal.

CAUTION: Do not move toilet after the wax seal is set.

3) Insert the cap base, washer and thread nuts onto the bolts and

hand tighten. Then tighten the bolts an additional ½ turn. Install

the bolt caps.

NOTE: check that cap does not t properly, check that cap base

has the correct side up indicated by THIS END UP (THIS PART

UP). Or check for interference of the mounting bolt with the cap.

Carefully cut the bolt length to allow the cap to t.

WARNING! Do not over-tighten the nuts. Damage to china or

plastic parts may result.