Ryobi RM480e Traduction Des Instructions Originales page 32

ADJUSTING CUTTING DECK WHEELS
See fig. 22
The cutting deck wheels should be positioned
approximately 1.27 cm. (1/2 in.) off the
ground when the mower is at the desired
cutting height. This will minimize the chance
of scalping the lawn in most situations. When
shipped, the wheels are positioned in Position
A.
To adjust the cutting deck wheels:
1. Park the product on a level surface and
engage the parking brake.
2. Turn off the product, and remove the start
key. Make sure that all moving parts have
come to a complete stop.
3. Set the cutting deck to the preferred
height setting.
4. Remove the nut and bolt securing the
cutting deck wheel in place.
5. Move the wheel to the preferred position.
Available hole positions are:
● 3.81 cm. (1.5 in.) (A)
● 4.44 cm (1.75 in.) (B)
● 5.08 cm. (2 in.) (C)
● 5.72 cm (2.25 in.) (D)
6. Replace the bolt and nut, and tighten
securely. Torque nut to 5.42-8.13 Nm
(4-6 ft. lbs.).
7. Repeat the steps with the remaining
cutting deck wheel, making sure that both
wheels are installed in the same position.
A
B
Nut
C
D
30 | English
REMOVING THE CUTTING DECK
See fig. 23
The cutting deck can be removed from the
mower to make accessing the blades easier
when changing.
1.
2.
3.
4.
5.
6.
Reverse the steps to reinstall the cutting deck
to the mower.
24 mm
bolt
Wheel
Fig 22
Make sure that the direction control
switch is in neutral (N) position, and blade
engage knob is down.
Turn off the product, engage the parking
brake, and remove the start key. Make
sure that all moving parts have come to a
complete stop.
Disconnect the cables that connect the
cutting deck to the mower.
Set the cutting deck to the lowest height.
Remove the 4 hitch pins and washers that
secure the cutting deck in place.
Slide the deck out from under the mower.
Cutting deck
Washer
Cable
Hitch pin
Fig 23