Maintenance
9
Maintenance
!
WARNING!
Working on gas and electrical installations may only be performed by
qualified technicians.
I
NOTE
The manufacturer recommends that the burner be cleaned after an
extended period, at least once a year (chapter "Cleaning the gas
burner" on page 36). If you need further assistance, please contact cus-
tomer service.
➤ Have the gas system and connected flues inspected before initial operation and
then every two years by an authorised professional to ensure they comply with
national safety requirements (in Europe, this is EN 1949).
➤ Clean the gas burner after prolonged exposure to gas, at least once a year (chap-
ter "Cleaning the gas burner" on page 36). When using autogas (tank or refillable
cylinders), the service interval is reduced to twice or four times a year, depending
on the level of contamination. Contamination in the gas burner becomes notice-
able with poor ignition process or deflagrations.
➤ Keep a record of any maintenance performed in the vehicle.
9.1
Cleaning the gas burner
!
WARNING!
• Close the gas valve to the refrigerator before cleaning the gas
burner.
• Allow the burner to cool down before cleaning it.
• Do not modify the gas equipment. The gas burner can be cleaned
without removing the gas equipment.
I
NOTE
fig. l, page 13 Up to fig. n, page 14:
The RMD 85xx series can be equipped with a standard unit (B) or a high-
performance unit (A).
➤ Remove the ventilation grille (fig. j, page 13).
➤ Only with high-performance unit:
Remove the condensation container (fig. l, page 13, A).
36
RMD8xxx
EN