Dometic RMD8 1 Série Notice D'utilisation page 34

Using the refrigerator
➤ Push the old panel upwards as far as the stop.
➤ Pull the old panel out of the door.
Removing the decorative trim without frame
Proceed as follows (fig. f, page 10):
➤ Push the old panel upwards as far as the stop.
➤ Pull the old panel out of the door.
Installing the decorative trim with frame
Proceed as follows (fig. e, page 9):
➤ Push the new panel upwards in the door as far as the stop.
➤ Push the new panel downwards into the door.
➤ Pull the new panel into the door trim still installed.
➤ insert the door trim again.
✓ The door trim is secure once it clicks into place.
Installing the decorative trim without frame
Freezer compartment door (fig. g, page 11):
➤ Push the new panel upwards in the door as far as the stop. Make sure that the new
panel fits the door at the left and right, and that it clicks into place.
➤ Push the new panel downwards into the door.
Refrigerator door:
➤ Push two spacers downwards into the door, if necessary (fig. h, page 11).
➤ Push the new panel upwards in the door as far as the stop. Make sure that the new
panel fits the door at the left and right, and that it clicks into place (fig. i,
page 12).
➤ Push the new panel downwards into the door (fig. i, page 12).
34
RMD8xxx
EN