TaoTronics TT-BA08 Mode D'emploi page 6

port or any active USB port.
3. The LED indicator will turn red when charging. It will
automatically turn off when the device is fully charged.
Note:
• You can use the adapter while it is charging.
• We recommend charging the unit for at least 2 hours before
using it for the rst time.
Pairing
Pair in TX mode:
1. Set the TT-BA08 to TX mode and connect it to your audio
transmitting device.
2. Place your Bluetooth audio receiving device, like earphones /
®
speakers, within a 3 feet / 1 meter range and set it to pairing
mode.
3. Turn on the TT-BA08 and tap the power button twice to enter
pairing mode. After approximately 10 seconds, pairing will
complete.
Pair in RX mode:
1. Set the TT-BA08 to RX mode and connect it to your
non-Bluetooth audio receiving device.
®
2. Turn on the TT-BA08 and tap the power button twice to enter
pairing mode.
3. Activate the Bluetooth function on your transmitting device –
®
phone / tablet, and search for the nearby Bluetooth
• For iOS: Settings>Bluetooth >On
®
• For Android: Settings>Bluetooth
4. Find "TaoTronics TT-BA08" in the search results and tap on it to
connect. Once connected, the LED indicator will turn solid blue.
Note:
• The adapter will enter pairing mode automatically when
powered on for the rst time.
• The original pairing memory will be cleared after a mode switch.
It will automatically start pairing each time it's powered on.
• If a PIN code is required for pairing, try 0000 (four zeroes),
8888 (four eights), 1111 (four ones), or 1234.
• The adapter can remember previously paired devices and
will attempt to pair with devices automatically, without going
into pairing mode.
devices:
®
>On>Scan for devices
®
07/08