Basic Properties; First Steps - TESTO 622 Mode D'emploi

4.2.

Basic properties

Pos: 23 /TD/Produktbeschreibung/Grundlegende Eigenschaften/testo 622/testo 622 Stromversorgung @ 3\mod_1233922706909_79.doc @ 23763 @ 5
Power supply
The instrument is powered optionally by:
• 4 batteries / rechargeable batteries, type AA
Pos: 24 /TD/Produktbeschreibung/Grundlegende Eigenschaften/testo 622/testo 622 Wandmontage @ 4\mod_1254468245886_79.doc @ 50984 @ 5
Wall mounting
The distance between the upper and lower drill hole is 63 mm.
Pos: 25 /TD/Überschriften/5. Erste Schritte @ 0\mod_1173774895039_79.doc @ 319 @ 1
5

First steps

Pos: 26 /TD/Erste Schritte/testo 622/testo 622 Schutzfolie entfernen @ 3\mod_1233927965698_79.doc @ 23802 @ 5
Removing the protective film
> Remove the protective film from the display
Pos: 27 /TD/Erste Schritte/testo 622/testo 622 Batterie einlegen @ 3\mod_1233927372010_79.doc @ 23783 @ 5
Inserting batteries/rechargeable batteries
1. Open the battery compartment on the rear of the instrument.
2. Insert batteries/rechargeable batteries (observe the polarity!)
3. Close the battery compartment.
Pos: 28 /TD/Überschriften/6. Produkt verwenden @ 0\mod_1173774928554_79.doc @ 328 @ 1
5 First steps
29