Additional Safety Instructions For Air-Powered Grease Gun; Specifications - Haussmann Xpert PNT130 Manuel De L'utilisateur

GENERAL SAFETY INSTRUCTIONS
SERVICE
Tool service must be performed only by qualified repair personnel.

When servicing a tool, use only identical replacement parts. Use only authorized

parts.
Use only the lubricants supplied with the tool and specified by the manufacturer.

AIR SUPPLY AND CONNECTIONS
The air supply connection must not hold pressure when air supply is

disconnected. If an incorrect fitting is used, the tool can remain charged with air
after disconnecting and thus will be able to work even after the air line is
disconnected, possibly causing injury.
Do not use any type of reactive gases, including, but not limited to, oxygen and

combustible gases, as a air source. Use filtered, lubricated, regulated
compressed air only. Use of a reactive gas instead of compressed air may cause
the tool to explode which will cause death or serious personal injury.
Use only a pressure-regulated compressed air source to limit the air pressure

supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 200 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air supply from tool:

a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.

ADDITIONAL SAFETY INSTRUCTIONS FOR AIR-POWERED GREASE GUN

Never use oxygen or any other combustible bottled gas as a air source as this

could cause explosion and serious personal injury (see Fig 1).
Disconnect tool from air supply hose before performing any tool maintenance and

during non-operation. For emergency stops and prevention of unintended
operation, a ball valve near the gun air supply is recommended.
Use clean, dry and regulated compressed air rated at 40 to 60 PSI, never exceed

the maximum allowed operating pressure 120 PSI.
Before operating the tool, make sure all the screws & caps are securely tightened

to prevent leakage.
Never modify this tool for any other applications. Only use parts, nozzles and

accessories recommended by manufacturer.
WARNING: Tool generates very high pressure on grease, tubes and fittings. A leak
could cause grease to penetrate skin resulting in severe injury or amputation.
WARNING: Before operation, inspect tool and attachments to ensure they have not
been damaged and are properly assembled.

SPECIFICATIONS

Recommended hose size: 3/8" (10 mm)

Maximum air pressure: 0.2 CFM @ 90 PSII

Average air consumption: 4.0 CFM @ 90 PSI

Air inlet: 1/4"(6 mm) NPT

Net weight: 3.1 lbs (1.4 KG)

14
PNT130
!
Fig.1
!