Replacing The Power Cable; Carbon Brushes; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BT-MA 1300 Mode D'emploi D'origine

Anleitung_BT_MA_1300_SPK1:_
GB
Important! The device is suitable for dry cutting only!
Use a cable/pipe detector to check for concealed
electric cables and gas and water pipes in the
wall before you start using the masonry channel
cutter.
Select the desired groove width (see 6.2) and
groove depth (see 5.1).
Important! Only ever guide the device along the
workpiece while switched on.
Place the device against the wall with the roller
(10) against the wall.
Switch on the device and then cut slowly into the
wall until the stop (7) rests against the wall.
Now you can cut the groove in the wall. Take care
with the cutting direction (a) as you do so. The
device must always be handled on a counter-
rotating basis otherwise there is a risk that it may
be forced out of the cut in an uncontrolled
manner.
Important! Cut in a straight line only. It is not
possible to cut curves.
At the end of the groove, swing the device out of
the groove before you switch it off.
You can then cut out the ridge between the two
grooves with a chisel.
It is prohibited to use the machine on
asbestos materials!

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
12
17.07.2009 9:38 Uhr Seite 12
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.

8.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.