Running Base; T80 / T85; Handrails - Tunturi T80/F Mode D'emploi

inside the handlebar.
on the sliders. Place the handlebar/meter unit on the
handrails so that the sliders located at the sides of the
handlebars fit the handrail grooves. Attach 2 screws (B)
to both sliders. Fasten all screws of the sliders. Fasten
the handrail bolts. Remove the protective film from the
display.

RUNNING BASE

Secure the attached lower frame and handlebar to the
running base according to the following instructions:
1. Remove the styrox foam piece from under the front
end of the running base.
2. Push the attached lower frame and handlebar under
the front end of the running base so that the front
support of the lower frame and the holes in the running
base are lined up. NOTE!
wire.
3. Secure the front support to the running base with
screws (C) and washers (D).
4
NOTE!
Do not remove the screws
Be careful not to damage the
4.
Connect the wire coming out of the left handrail
with the connector in the running base. Secure the
coiled cable to the lower frame with the coupler and the
screw so that the coiled part of the cable remains visible
between the coupler and the connector.
5.
Lift the running base up and lock it into the storage
position. Cut the gas spring ribbons, push the running
base forward to take weight off the base and secure both
gas springs to the lower frame with the nylock nuts (E).
NOTE! Do not secure the nuts too tight so that the gas
spring coupler can move freely!
6. Move the running base (see Moving and Storage).
Lower the running base onto the floor and make
sure that the running base is steady. If the treadmill
feels unstable, use the adjustable feet at the back of
the treadmill under the running base to stabilize the
treadmill: undo the fastening nuts on the adjustable feet
and adjust the height of the feet. Secure the fastening
nuts.

T80 / T85

HANDRAILS

Secure the handrails to the running base with four short
hex screws (A) and washers (B) and two long hex screws
(C) and washers (D). Be careful not to damage the wire
coming out of the left handrail.
these bolts until the handlebar and meter have been
secured.
NOTE! Do not tighten