Electronic Controller - Vasco E-Bano BM-EL Manuel D'utilisation Et D'installation

ELECTRONIC CONTROLLER

OPERATION
[ + ] Button
Button [Prog]
[On/stand-by]
Button
[ - ] Button
1. POWER ON/STAND-BY
Press the [On/Stand-by] key to turn on the device or to enter the "Stand-by" mode. When activated, the bottom part of the display
shows the current time, while the configured operative mode and the temperature are shown in the upper part. When in "Stand-by"
mode current time, day of the week and the message: " Stb" are displayed. When the device goes into "Stand-by" mode it beeps twice
for 0.5s. When the device is activated it beeps once for 1s.
2. "COMFORT" and "NIGHT" MODES
Two different levels of temperature can be set:
-"COMFORT" temperature: It is the temperature used for "Chrono", "Fil-Pilote" and "Comfort" modes.
-"NIGHT" temperature: It is the temperature used for the "Night" and "Chrono" modes.
The desired temperature can be set pressing the [+] and [-] buttons. The range of configurable temperature is 7°C - 32°C.
IMPORTANT!
The temperature of "Night" mode must be below to the "Comfort" mode temperature. For this reason the "Night" mode temperature
can be set to a value between 7°C and the (configured "Comfort" mode temperature
- 0.5°C). The temperature of "Comfort" mode can be configured in the whole (Night temperature + 0.5°C) ÷ 32°C range.
3. OPERATING THE DEVICE
Press the [PROG] button to select the desired operative mode. An icon on the display indicates the selected operating mode,
according to the following table:
COMFORT MODE
The "Comfort" stably maintains the room temperature to a selected value. To set this operative mode:
-Press the [Prog] button until the display shows the "Comfort" icon
-Set the desired temperature through [+] and [-] buttons and wait until the displayed temperature stops blinking.
NIGHT MODE
The "Night" mode sets a value of temperature below the "Comfort" temperature value.
It is suggested to set this operating mode during the night or when the room is not occupied for 2 or more hours.
-Press the [Prog] button until the display shows the " Night" icon
-Set the desired temperature through [+] and [-] buttons and wait until the displayed temperature stops blinking.
ANTIFREEZE MODE
In "Antifreeze" mode the temperature is fixed to 7°C. The device activates the heating element when the room temperature falls below
7°C. It is suggested to set this operating mode when the room is not occupied for several days. Press the [Prog] button until the
display shows the "Antifreeze" icon
TIMER-2H MODE
The "Timer 2h" mode can be used to quickly warm up the room.
-Press the [Prog] button until the display shows the "2h" icon.
The device is activated at the maximum power for 2 hours, up to a maximum room temperature of 32°C. The "Timer-2h" mode is
automatically deactivated after a period of 2 hours and the device returns to the operative mode previously set. The user can switch to
another operative mode at any time by simply pressing the [PROG] button.
FIL-PILOTE MODE
In "Fil-Pilote" mode the device is managed by a central control system that sets the operating mode for all the connected devices. The
device operates with the most advanced "Fil-Pilote" system with six commands.
External sensor:
Guarantees a stable room temperature
ONLY FOR FRANCE
EN
Indicator of active
heating element
Comfort/Night bar
(Chrono mode)
Operating mode icons:
- Fil Pilote (FRANCE)
- Comfort
- Night
- Antifreeze
- Timer 2h
Open window
- Chrono
detection
24h indicator
Configured
temperature
Time
Day of
Key-lock
the week