Sissel HYDROTEMP Mode D'emploi page 5

APPLICATION
Simple, incremental heating in the microwave: Place product in clean microwave and
set to 600 or 800 Watt. Heat for 1 minute, remove from microwave and touch-test.
If additional heat is desired, continue heating in 20 second increments. A total heating of 2 minutes should
not be exceeded. Provides heat for about 30 minutes. Heating in the microwave permits precise tempera-
ture regulation, an undesired independent heating of the product does not occur.
If it is necessary to fold SISSEL
through the heating cycle, remove and reverse the fold. Continue heating the remaining time.
® ®
Place SISSEL Hydrotemp on the bare skin or a thin undershirt (may get slightly wet).
Do not store in an airtight container after the application, so that the special micro beads may continue
drawing moisture from the surrounding air. After repeated use, let product rest for about 2 hours.
CLEANING, MATERIAL, STORAGE
I If necessary, wipe product with moist towel, do not moisten or wet completely.
Do not wash in washing machine.
I Materials: Polyster cover with PU foam padding, microbeads, odor-free, dust-free, latex-free.
I Waste disposal: domestic waste.
I Store in a clean place, out of the sun.
® ®
Hydrotemp pack to fit in the microwave, fold it loosely. Half way