Restriction Of Use; Maintenance; Changing The Blade; Use - UFLOOR WOLFF ECO-STRIPPER 230 V Mode D'emploi

3.3 Restriction of use

The ECO-STRIPPER is exclusively for removing bonded floor
coverings in dry environments.
It should not be used for any other purpose.
3.4 Genuine Spare parts
Spare parts and accessories are manufactured uniquely for the
ECO-STRIPPER. It must be emphasized that parts obtained
from unauthorized sources must not be used.
WOLFF cannot be held responsible for the performance of or
any damage arising from the use of machines in which genuine
spare parts have not been used. This is particularly important with
replacement blades.

4.0 Maintenance

The ECO-STRIPPER is maintenance-free.

4.1 Changing the blade

Disconnect the power supply before changing the blade. Use
work gloves for your own safety.
put on the blade protection (enclosed in the tools set)
clean and loosen the screws of the blade mounting.
Set the wrench at a position opposite to the blade to avoid
injury.
replace the blade.
Make sure that the blade fits in exactly into the support. On nor-
mal and hard subfloors the bevel of the blade should show
upwards (1), on soft subfloors (e.g. chipboards) the bevel should
show downwards (2).

5.0 Use

5.1 Starting
Mount the long internal tube with 2 screws (A) to the handle
support.
Telescope the outer tube over it. The length of the handle
may be adjusted by sliding the outer tube and locked with
screw (C).
Place the handle into the end of the tube and latch the
locking.
For your safety the ECO-STRIPPER comes with blade not mounted.
Make sure that the power supply is disconnected before
mounting the blade.
The sharp bevel of the blade must sit close to its support.
It is fixed with 4 screws.
Fix the mains cable at the handle in order to keep it free from the
blade and the wheels.
01/2005 Fugenfrä FugenfräseFRÄFugenfräse FRÄSMASTER
Wolff cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
Very sharp blade! You may cause injury without using
the blade protection!
A
B
1
2
C
11