Zibro D 112 Manuel D'utilisation page 56

OPERATION
1 Insert the plug in the wall outlet.
2 Ensure that the water container has been positioned correctly. If the
switches on when you use the device for the first time, remove the water container
from the device and replace it in the correct position.
3 Press the
used to set the desired humidity level. The hydrostat is adjustable from 30% to 85%.
The value increases by 5% each time you press the button. The display indicates the
set humidity (SET HUMIDITY) and also the relative humidity (ROOM HUMIDITY).
The device starts to dehumidify when the relative humidity in the room is higher than the
set value.
The device switches off automatically when the set value is reached, and restarts when the
humidity in the room rises again.
4 Select the ventilator speed by pressing the
(= low) and
5 The timer function enables you to switch the device off after a certain time. The
operating time can be set between 1 and 12 hours with the
you press the button, the running time is extended by 1 hour. This will be shown on
the display. When the pre-set time has elapsed, the device will switch off.
6 The dehumidifier DX118 is equipped with a heating function. Press the
turn on the heating. By pressing the
turned off.
7 Press the
4
56
DX118
-button to switch the dehumidifier on. The
(= high).
-button to turn the device off.
-adjustment buttons are
-button. You can select two settings:
-button. Every time
button again, the heating function will be
-light
button to