Operation; Serving; Emptying The Appliance - Caterlite J709 Mode D'emploi

Telephone Helpline: 0845 146 2887 (United Kingdom)

Operation

Remove the appliance from the
1.
packaging. Make sure that all protective
plastic film and plastic coatings are
thoroughly removed from all surfaces.
Note: Before using for the first
time, clean the interior of the
appliance and all parts in
warm soapy water, then rinse
thoroughly.
Ensure the Temperature Control knob is
2.
set to '0'.
Remove the lid and fill the appliance to
3.
at least half of its capacity.
Replace the lid.Twist to lock.
4.
Connect to the mains power supply and
5.
turn the power switch On. The Power
Indicator light illuminates.
Set the Temperature Control knob to the
6.
required temperature. The Heat
Indicator illuminates and the appliance
heats the water.
WARNING: Reduce the set temperature if the water begins to boil. DO NOT allow the
water to boil constantly.
When the water has reached the set temperature the 'Warm' light illuminates and the water is ready to
7.
be dispensed.
Note: Once the water temperature drops 5-10ºC then the appliance will reheat the
water.

Serving

Place a suitable vessel beneath the tap.
1.
Pull the tap towards you to begin dispensing.
2.
Raise the tap handle to close the tap.
3.

Emptying the Appliance

Drain the appliance by using the tap to empty.
Thermal Cut-out reset switch
Temperature Control knob
UK
Lid
Urn
Level indicator
Tap
On/Off switch
Heat Indicator
Warm
Indicator
2