Publicité
Les langues disponibles
Les langues disponibles
REPARATIONS
Any hydraulic jack found to be damaged in any way, is found to be worn or operates abnormally, believed to have
subjected to an abnormal load, shall be REMOVED FROM SERVICE UNTIL FULL REPAIRED. Owners and/or operators
should be aware that repair of the equipment requires specialized knowledge and facilities. Only factory authorized
parts, labels and decals shall be used on this equipment. Contact customer service department.
WARNING!
• READ, STUDY AND UNDERSTAND ALL WARNINGS AND OPERATION INSTRUCTIONS PRIOR TO USE.
• DO NOT OVERLOAD THIS JACK BEYOND THE RATED CAPACITY.
• THIS JACK IS DESIGNED FOR USE ONLY ON HARD LEVEL SURFACES CAPABLE OF SUSTAINING THE LOAD. USE ON
OTHER THAN HARD LEVEL SURFACES CAN RESULT IN JACK INSTABILITY AND POSSIBLE LOSS OF LOAD.
• THIS IS A LIFTING DEVICE ONLY. IMMEDIATELY AFTER LIFTING, SUPPORT THE VEHICLE WITH JACK STANDS.
• DO NOT GET UNDER OR ALLOW ANYONE UNDER THE VEHICLE UNTIL IT HAS BEEN SUPPORTED BY JACK STANDS.
• DO NOT MOVE OR DOLLY THE VEHICLE WHILE ON THE JACK.
• LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE MANUFACTURER.
• CENTER LOAD ON SADDLE PRIOR TO LIFTING.
• NO ALTERATIONS TO THE JACK SHALL BE MADE.
• FAILURE OR HEED THESE WARNINGS MAY RESULT IN PERSONAL INJURY AND PROPERTY DAMAGE.
• THE PRESSURE VALVE HAS BEEN SEALED BY THE FACTORY. NEVER ADJUST THE PRESSURE VALVE BY YOUR SELF
OTHERWISE YOU LOOSE YOUR GUARANTEE-RIGHT. CONTACT CUSTOMER SERVICE DEPARTMENT TO LET SEAL THE
PRESSURE VALVE BY AUTHORIZED PEOPLE AT 5 TONS LIMITED ONLY.
Because of potential hazards associated with the misuses of equipment of this type, no alterations shall be made to the
product without written authorization of KRAFTWERK as manufacturer and supplier.
ASSEMBLING OF JACK
1. Remove and dispose of the metal rod which is holding the handle socket down (See fig. 8).
2. Position the handle over the spring. Push it down whilst ensuring that the control rod is located in the top securing
whole (See fig. 9). Tighten the handle bolt securely and test to make sure the handle will not pull out.
8
fig. 8
fig. 9
Publicité
