Program Selection; Care & Maintenance - Danby DWM028WDB-3 Manuel Du Propriétaire

OPERATING INSTRUCTIONS

PROGRAM SELECTION

Press the water level button to choose the size of
wash load that will be completed.
Press the program button repeatedly to choose the
desired program. The programs will cycle in the
following order:
1. Wash & Rinse & Spin
2. Wash & Rinse
3. Rinse & Spin
4. Wash
5. Rinse
6. Spin
7. Delicates
Consult the below table for information on program
times.
• Normal wash time is approximately 10 minutes.
• Normal rinse time is approximately 15 minutes.
• Normal spin time is approximately 5 minutes.
Note: Program times can vary based on the amount
of clothing in the washing machine and the water
pressure going into the inlet hose.
Program
Wash & Rinse & Spin
Wash & Rinse
Rinse & Spin
Wash
Rinse
Spin
Delicates
• Close the lid and press the Start/Pause button to
begin the desired program.
• A program can be paused once it is in operation
by pressing the Start/Pause button.
• When a program is fi nished, an alarm will
sound.
• To reduce the risk of electric shock and water
leaking, disconnect the water inlet hose and the
power cord when the appliance is not in use.
Total Time
30 minutes
25 minutes
20 minutes
10 minutes
15 minutes
5 minutes
17 minutes
CLEANING
Before performing any cleaning or maintenance,
ensure that the water inlet hose has been
disconnected and that the power cord has been
unplugged.
Clean the outside of the appliance with a warm,
damp cloth. Avoid using detergents or chemicals as
this can damage or discolor the cabinet.
LINT FILTER
The lint fi lter should be cleaned after each program.
1. Remove the lint fi lter from the inner tub of the
appliance.
2. Open the lint fi lter and remove any lint that has
accumulated.
3. The lint fi lter can be rinsed under cold water to
remove any lint build up. Do not use detergents
or chemicals on the lint fi lter.
4. Ensure that the lint fi lter is replaced in the
appliance before beginning a new program.
WATER INLET
The water inlet may require periodic cleaning to
remove debris or hard water build up.
1. Ensure the water inlet hose has been
disconnected from the appliance.
2. Remove the fi lter screen from the inlet valve and
remove any debris or hard water build up. The
fi lter screen can be rinsed under cold water to
remove any build up.
3. Ensure that the fi lter screen is replaced in the
water inlet valve before reattached the water
inlet hose.
VINEGAR RINSE
A rinse of vinegar and water can be run through the
washing machine to remove any stains on the inner
tub or any lingering odors.
Place 1/2 cup of vinegar in the washine machine
and choose the highest water level. Allow the
appliance to run a full Wash & Rinse & Spin
program with no laundry to remove stains and
odors.
6
CARE & MAINTENANCE