Danby DWM028WDB-3 Manuel Du Propriétaire page 5

INSTALLATION INSTRUCTIONS
BASE PLATE INSTALLATION
Place the appliance on its back on a soft blanket or
towel to avoid damaging fl ooring or scratching the
washer cabinet. Attach the base plate to the bottom
of the appliance using the screws provided.
Ensure that the base foam and fi xing frame have
been removed from the bottom of the appliance
before attaching the base plate.
LEVELLING INSTRUCTIONS
It is important that the appliance is level to help
avoid unbalanced loads and excessive noise.
1. Turn the levelling foot counter-clockwise until
the top of the foot it touching the bottom of the
cabinet.
2. Slowly turn the levelling foot clockwise until the
appliance is level.
Note: This appliance includes one adjustable foot
on the front, three solid feet and two rollers on the
back.
WATER INLET HOSE INSTALLATION
One end of the inlet hose assembly is bent at a 90°
angle. Attach this end to the water inlet on the top
of the appliance.
Remove the aerator from the faucet that will be used
as a water supply. Attach the other end of the inlet
hose assembly to the faucet.
Turn on the water supply and check both
connections for leaks. If any leaks are found, turn
off the water, remove the hose and use tefl on tape
to ensure a tight seal at the connection. Be careful
when removing the hose as it will be fi lled with
water.
Important: Do not connect the water inlet hose to
a hot water supply. This appliance is for cold water
connection only.
DRAIN HOSE INSTALLATION
The drain hose will arrive pre-attached to the
appliance. It will default to exiting the right side of
the appliance. It can be changed to a left hand side
exit by removing the base plate from the bottom of
the appliance and re-routing the drain hose. Make
sure to replace the base plate after moving the hose.
When running the drain hose to a drain, ensure that
there are no bends in the hose as this can cause a
blockage and impede the drain function.
The drain hose can be directed upward toward a
sink or bucket but ensure that the hose does not rise
more than 100 cm (39.4 in) from the ground as this
can impact the drain function.
4