Declaration Of Conformity - Boss GT-100 Mode D'emploi

Masquer les pouces Voir aussi pour GT-100:
Table des Matières

Publicité

IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.
BLUE:
BROWN:
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.
This product complies with the requirements of EMC Directive 2004/108/EC.
Ce produit répond aux normes de la directive CEM 2004/108/CE.
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment requires shielded interface cables in order to meet FCC class B limit.
Any unauthorized changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
Model Name :
GT-100
Type of Equipment :
Guitar Effects
Responsible Party :
Roland Corporation U.S.
Address :
5100 S. Eastern Avenue, Los Angeles, CA 90040-2938
Telephone :
(323) 890-3700
NEUTRAL
LIVE
NOTICE
AVIS
WARNING

DECLARATION OF CONFORMITY

Compliance Information Statement
For the U.K.
Pour le Royaume Uni
For EU Countries
Pour les pays de l'UE
For the USA
Pour les Etats-Unis
For Canada
Pour le Canada
For C.A. US ( Proposition 65 )
Pour la Californie (Proposition 65)
For the USA
Pour les Etats-Unis
65

Publicité

Table des Matières
loading

Table des Matières