Drilling The Holes Into The Mounting Plate - Lenze 9300 vector Instructions De Montage

4.3

Drilling the holes into the mounting plate

Assembly space
Left/right of other controllers
Left/right of a non−heat−conducting wall
Top/bottom
Comply with the clearances given to ensure a sufficient cooling of the controller. When
using an air lock, different clearances apply (see Mounting Instructions for the air lock).
b
d
Fig.4−2
a1
450 mm
1. Mark the bore holes on the mounting plate according to the figure.
2. Drill the holes into the mounting plate.
EDKVF9338 DE/EN/FR 4.0
Drilling the holes into the mounting plate
a1
a2
a3
a2
a1
Bore holes in the mounting plate for fixing the controller
a2
340 mm
l
Mechanical installation
Minimum clearance
30 mm
100 mm
200 mm
a3 b
225 mm 1005 mm
4
93vec048
d
9 mm (12x)
77