Useful Remote Control Features; Learning Function Of The Remote Control Unit; Using The Learning Function; Presetting Manufacture Codes - Pioneer PureVision PDP-5050SX Mode D'emploi

12

Useful Remote Control Features

Learning function of the remote control
unit
You can operate the connected AV products (AV Receiver, Cable
Box, SAT tuner, VCR, DVD, DVD recorder, LD) using the learning
function of your remote control unit. This remote control unit
has a function that can memorize each remote control code.
2 to 5 cm (13/16 to 2 inches)
Remote control
(Supplied accessory)

Using the learning function

1
Slide the Mode switch to match the device whose remote
control signal you want to be learned.
2
Press EDIT/LEARN and 2 at the same time.
•The LED flashes.
3
Press a button to be learned.
• The LED lights up.
• For the functions that can be learned, see pages 48 to
52.
• When learning is finished, the LED starts flashing
again.
4
Press EDIT/LEARN again to exit the Learn mode.
• To exit the Learn mode halfway, press EDIT/LEARN again.
• If the Mode switch selection is changed when in the Learn mode,
the Learn mode is cancelled.
• If no operation is performed for more than one minute, the Learn
mode is cancelled.
• It takes about 2 seconds to finish code transmission. Do not interrupt
it halfway. Wait until the LED flashes again.
• To reset the Learn setting, have the LED blinking as in step 2 and
then keep the remote control unit's TV a button pressed for at least
2 seconds.
46
En
12-PDP5050SX-Eng (46-52)
Remote control of
AV product
46

Presetting manufacture codes

1
Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2
Press EDIT/LEARN and 1 at the same time.
• The LED flashes.
3
Press 0 – 9 to enter the manufacture code. See page 47.
• Preset mode is finished once the LED no longer lights
up.
• To exit the Edit mode halfway, press EDIT/LEARN again.
• If the Mode switch selection is changed when in the Edit mode, the
Edit mode is cancelled.
• If no operation is performed for more than one minute, the Edit mode
is cancelled.
• When you enter a code not listed, the LED flashes quickly.
• If the table on page 47 does not include your desired manufacturer or
the remote control does not work, you can make the memory learn
its signal by the Learn mode.
• The initial mode is "000" (PIONEER).
05.2.25, 11:02 AM