Warning Indicators - SilverCrest SPWS 180 A1 Mode D'emploi

Attention
:
NEVER jump onto the glass scale, this could irre-
parably damage it.
4. Stand briefly on the scales so that the device
turns itself on.
5. Press the language button 4 repeatedly until the
desired language appears on the left of the dis-
play 2.
6. Set the desired volume level using the volume
control 3. To deactivate the voice, turn the volume
control 3 all the way to the right until it clicks
into place.
Notice!
The language and the sound volume must only be
adjusted on the first use.
7. Stand with both feet on the scales. Stand as still
as possible and without displacing your weight.
8. During the weighing process (about 5 seconds)
the displayed value increases until your weight
is determined.
9. When your weight is determined, the result blinks
twice on the display 2 and it speaks your deter-
mined weight.
68.8
After you have stepped down from the scale it
sounds "Ready for operation" and you can then
start another measurement.
If you simply wait, the scale will indicate by a dou-
ble beep that it has switched itself off.

Warning indicators

Should your weight exceed the maximum weighing
capacity of 180 kg / 396 lb, "0 - Ld" is shown in the
display 2. You should IMMEDIATELY step down
from the scale, otherwise it could be damaged.
If the display 2 shows "L0" and "Low Battery"
sounds, you must replace the batteries.
If the display 2 shows "Err" and "Error" sounds, the
scale cannot measure. In this case, step down from
the scale, wait a few seconds and then try again.
Take note that you need to both stand still and not
interrupt the weighing procedure.
- 45 -