Installation - HumanTechnik lisa Mode D'emploi

8. Installation of the combined detector
Before installation, couple the combined detector with the
respective Lisa receiver units (see section 14).
In order to avoid injuries or damage, the device must be reliably fixed to
the ceiling in accordance with this instruction.
Installation with screws and wall plugs:
Use the supplied fixing material for installation of the combined detec-
EN
tor. If other screws are used, these must not project into the base more
than 5 mm. The mounting surface must be even!
The small self-adhesive area serves only to find the position for the
base and is not intended to hold the combined detector!
1. Hold the base to the desired location. Mark the positions of both holes.
2. Drill the holes with an according drill.
3. Push a plug into each hole.
4. Screw the base lightly to the surface, hold the base in place and tighten
the screws - but not too much.
5. Insert the detector into the base, with the markings in alignment.
57