stayer LEN751E Instructions D'emploi page 12

Intended Use
The machine is intended for dry sanding of
wood, plastic, metal, filler and coated surfaces
at high removal rates.
Dust Extraction
The dust that is produced while working can be
detrimental to health,
explosive.
Suitable safety measures are required.
Examples: Some dusts are regarded as
carcinogenic.
Use suitable dust/chip extraction and wear a
dust respirator.
Dust from light alloys can burn or explode. Always
keep the workplace clean,
materials are particularly dangerous.
If your tool is equipped with a dust bag, empty it
frequently and after completion of sanding.
Be particularly careful when disposing of dust, as
materials in fine particle form may be explosive.
Do not throw sanding dust on an open fire.
Spontaneous combustion may in time, result
from mixture of oil or water with dust particles.
Internal Vacuuming with Dust Box
Attaching the dust box:
Attach the extraction adapter onto the outlet
piece setzen. Attach
extraction adapter and allow it to snap in.
External Dust Extraction (Accessory)
The machine can be plugged directly into the
receptacle of a STAYER all-purpose vacuum
cleaner with remote
vacuum cleaner starts automatically when the
machine is switched on.
The vacuum cleaner must be suitable for the
material to be worked.
When vacuuming dry dust that is especially
detrimental to health or carcinogenic
special vacuum cleaner.
For external dust extraction with a vacuum
cleaner, an extraction adapter must be used as
required (see accessories). Insert extraction
adapter and vacuum connection firmly.
inflammable
as blends of
the dust box onto the
control starting. The
, use a
ENGLISH
8
Changing the Tool
Before any work on the machine itself, pull
the mains plug.
Swivel out the clamping lever fully. The sanding belt
is now loose and can be taken off.
Mount a new sanding belt.
Swivel the clamping lever back again to its original
position.
Lift the machine from where it is lying and switch it on.
or
Correct the position of the belt by pressing the
adjusting knob until the edge of the sanding belt
runs flush with the backing plate.
Make sure that the sanding belt does not rub into the
housing. Check the position of the sanding belt
regularly and if necessary, correct it again using the
adjusting knob.
Store sanding belts only hanging; avoid creasing, as
this makes the belts unusable!
Initial Operation
Observe correct mains voltage: The voltage of the
power source must agree with the voltage specified
on the nameplate of the machine.
Switching On and Off
To start the machine, press the On/Off switch and
keep it depressed.
Lock the pushed On/Off switch by pressing the lock-
on button.
To switch off the machine, release the On/Off switch
or push and release it then.
8