Mig Welding Conector; Mig Torch; Connector For Mig Welding With A Traditional Torch; Connector For Mig Welding With A Spool Or Push-Pull Torch - Fimer TM 236 DUAL PULSE SYNERGIC Manuel D'emploi

Please refer to the following table for the
correct welding current settings:
WORKPIECE WIRE
THICKNESS DIAMETER
mm mm
0.8 - 1.0 0.6 - 0.8 60-100
1.5 - 2.0 0.8 - 1.0 80-120
2.0 - 3.0 1.0 - 1.2 100-130
3.0 - 4.0 1.2
> 4.0 1
> 4.0 1.2
5.

MIG WELDING CONECTOR

The connector for the welding cables comes
with a quick connect system that uses
appropriate connectors.

5.1. MIG TORCH

We would advise you to carry out regular
controls on the condition of the welding
torch; in particular, always check the nozz-
le/gas blowpipe (Fig. 4A) the wire feeder tip
(Fig. 4B), and the internal sheath of the
torch. These parts must be kept well-cleaned
and intact. If the wire stops threading correc-
tly. replace the wire guide.
N.B. Each wire and diameter corresponds
to an appropriate wire feeder tip and
sheath. Always make sure you are using
the correct type.
5.2 CONNECTOR FOR MIG WELDING
with a traditional torch
1) Connect the earth cable to the appropriate
'-' socket on the front of the device (12 of Fig 1).
Insert the connector by lining up the key with
the groove and turn in a clockwise direction
until it stops. Do not fasten too tightly!
2) Connect the torch to the appropriate
socket in the front of the device (16 di Fig 1),
turning the connector in a clockwise direction
until it stops. Do not fasten too tightly!
16
WELDING
ARC
CURRENT
A
Short-Arc
Short-Arc
Short-Arc
120-200
Short-Arc
150÷200
Spray-Arc
200÷300
Spray-Arc
Warning: the machine is provided with
sockets for the MIG welding torch (Fig 4) This
accessory has a long life-time if periodical
controls of the gas nozzle and the wire-
feeder tip are carried out (Fig 4A) (Fig 4B).
These parts must be kept well-cleaned and
intact. Replace the wire guide when the wire
no longer threads correctly.
5.3 CONNECTOR FOR MIG WELDING
with a Spool or Push-Pull torch
1) Connect the earth cable to the appropriate '-'
socket. (12 of figure 1). Insert by lining up the
key with the groove and turn in a clockwise
direction until it stops. Do not fasten too tightly!
2) Connect the torch to the appropriate socket
on the front of the device (16 of Fig 1),
turning in a clockwise direction until it stops.
Do not fasten too tightly!
3) Insert the connector of the torch into the
appropriate female socket.
MIG WELDING:
Connect the pressure regulator to the cylin-
der, after which attach the gas tube of the
torch to the latter.
MIG welding is usual-
ly carried out with a
constant current, with
a positive pole ("+
"see fig.5).
The MIG torch cable
is connected to the
Euroconnector (16
of fig.1), whilst the
earth cable of the
workpiece is con-
nected to the '-'
socket on the front
(12 di fig.1).
At this stage adjust the welding current using
the potentiometer (9 of Fig.1), situated on the
front panel.
The diameter of the electrode and the wel-
ding current settings must be selected accor-
ding to the thickness of the workpiece.
Fig.5