Sunbeam GCSBBV212 Notice D'emploi page 3

F Y C i
eatures oF our lassiC ron
1. Spray Mist Release
2. Covered Water Fill Hole
3. Steam Dial
4. Spray Mist Button
5. Shot of Steam Button
®
6. Power Indicator Light
7. 360° Tangle-Free Swivel Cord
8. Fabric Select Dial
9. Maximum Fill Line
10. Self Clean Button
11. See-Through Water Reservoir
12. Soleplate
t f W R
o Ill the ateR eseRvoIR (use tap water)
1. Make sure the iron is unplugged. Set the Steam Dial to
Select Dial to MIN.
2. Lift the Water Fill Hole Cover.
3. Fill an easy-pour measuring cup with tap water and pour water into iron water
reservoir. Do not fill water reservoir beyond maximum fill level.
WARNING:
To prevent the risk of burns, be careful when filling a hot iron with
water. Hot metal parts, hot water and steam can cause injuries.
d I
Ry RonIng
1. Make sure the Steam Dial is turned to the
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the large Fabric Select Dial to the fabric setting you desire. Allow the iron
to heat for 2 minutes. While the iron is heating, make sure it is sitting on its
heel rest on a stable, protected surface.
6
5
4
3
2
1
9
10
11
12
Visit www.sunbeam.ca for an Ironing Guide and Ironing Tips
Voyez le guide et les conseils de repassage au www.sunbeam.ca
(Dry) and the Fabric
(Dry) setting.
7
8
damage the cord.
s y I
toRIng ouR Ron
1. Turn off iron following instructions above. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir after
each use for a longer iron life. To do so, unplug the iron, turn the iron upside
down, open the fill hole cover, and allow water to flow from the fill hole. Shake
the iron gently to remove trapped water drops.
3. Loosely loop the power cord around the heel rest and store the iron on its heel rest.
IMPORTANT:
Wrapping the cord around the iron too tightly can damage
the cord.
m
aIntaInIng
c s :
turn off iron following instructions above. Clean the
leanIng the oleplate
soleplate if starch or other residue accumulate.
t s :
allow the iron to cool and then wipe it with a soft,
o clean the oleplate
C
araCtéristiques du Fer Classique
1. Orifice d'atomisation
2. Orifice de remplissage à volet
3. Variateur de vapeur
4. Bouton d'atomisation
5. Bouton de survapeur Shot of Steam
6. Voyant d'alimentation
7. Cordon articulé 360°, non emmêlant
8. Cadran de sélection des textiles
9. Repère de remplissage maximal
10. Bouton d'autonettoyage
11. Réservoir translucide
12. Semelle
y c I
ouR lassIc Ron
MD