Connecting The Remote Control Panel; Commissioning After Installation; Automatic Switching Between Mass Inverter, The Ac Genset And/Or Shore Power - Mastervolt Mass SINE 12/1000 Mode D'emploi

INSTALLATION
CAREFUL !
Reversing positive and negative will cause
major damage to the inverter. This damage
is not covered by the guarantee.
CAREFUL !
Too-thin cables and/or loose connections
can cause dangerous overheating of the
cables and/or terminals. Therefore tighten
all connections well, in order to limit tran-
sistion resistance as much as possible.
Use DC cables of the correct size.
3.5 CONNECTING THE REMOTE CONTROL
PANEL
The remote control panel C4-RI for the MASS inver-
ter comprises an off/on switch and two LEDs. The
LED 'inverter on' indicates proper functioning of the
inverter and the availability of 230/117V AC output
voltage. The LED 'failure' indicates overload, over-
temperature or too low voltage. Connect the remote
control panel by means of a telephone cable (not
supplied with the panel), see fig. 5.
3.6

COMMISSIONING AFTER INSTALLATION

Carefully check the polarity of the connections.
Careful !
Only insert the inverter fuse if the polarity is
correct. Switching on with incorrect polarity
will damage the inverter irreparably. The
inverter fuse cannot prevent this.
30
If the connections are correct:
• check whether the on/off switch is in the "OFF"
position;
• when inserting the inverter fuse, a spark will
occur, caused by the capacitor used in the in-
verter. This is normal.
The inverter is now ready for use.
3.7 AUTOMATIC SWITCHING BETWEEN MASS
INVERTER, THE AC GENSET AND/OR
SHORE POWER
Please contact your Mastervolt supplier if you intend
to use the inverter with a genset or shore power
connection. Handswitched or simple relay switching
systems could damage your inverter, because of the
lack off time delay. This kind of damage is not cover-
ed by the warranty.
November 2000 / Mass Sine 12/1200, 12/2000, 24/1500, 24/2500 & 48/2500/ EN