Installation; Environment; Wiring - Mastervolt Mass SINE 12/1000 Mode D'emploi

3

INSTALLATION

During installation and commissioning of
the MASS inverter, the Safety Guidelines
and Measures are applicable at all times.
See chapter 2 of this manual.
3.1

ENVIRONMENT

Install the MASS inverter in a dry, well ventilated,
dust free situation. Locate the inverter as close as
possible to the DC distribution in order to keep the
battery cables short. Do not locate the inverter in the
same compartment as the batteries. The heat of the
inverter is discharged by a fan with a variable speed,
from the top and side of the cabinet to the bottom of
the cabinet.
When fitting the inverter be sure that:
• the air flow is not obstructed;
• the inverter is mounted vertically;
• no water and/or dust can enter the cabinet.
Never use the inverter in locations where
there is gas or explosion danger!
3.2

WIRING

The routing of the wires has influence on the EMC
behaviour of the system in which the inverter is a
component. This is caused by the fact that wires are
excellent receivers and transmitters of radio frequen-
cy electro magnetic interference. Most problems ori-
ginate from mutual influencing between wires and
cables.
EN / Mass Sine 12/1200, 12/2000, 24/1500, 24/2500 & 48/2500 / June 2000
Never remove the type number plate!
Important technical data required for servi-
ce, maintenance and later delivery of parts
can be obtained from the type number
plate (see fig. 1).
Type: SINE 12/1200 inverter
Part no: 012020500
Input: 12V DC (10 ... 16V)
Output: 230V 50Hz sine wave
Output power: 1200VA
Fig. 1: Type number plate Mass Sine inverter.
INSTALLATION
27