Toasting Tips; Care And Cleaning Instructions - Nesco T1000 Manuel De L'utilisateur

• Toasting is a combination of drying and cooking the bread and, because moisture
levels differ from one bread to another, toasting times can vary.
• For slightly dry bread, use a lower setting than normal.
• For fresh bread or whole wheat bread, use a higher setting than normal.
• Bread which has a very uneven surface will require a higher setting.
• Thicker cut pieces of bread (including crumpets) will take longer to toast -
sometimes significantly longer. This is because more moisture must be evaporated
from the bread before toasting can occur. Very thick pieces of bread may require two
toasting cycles.
• When toasting raisin or other fruit breads, remove any loose raisins or fruit from the
surface of the bread before putting it into your toaster. This will help prevent fruit
pieces from falling into your toaster or sticking to the guard wires in the toasting
slot.
• Single slice toasting - If you are toasting a single slice of bread, set the browning
control to a lower setting than normal. By using a lower setting when toasting a
single slice of bread, it will not be over toasted.
• If your toaster jams:
• Never use a knife or any other utensil or implement to remove jammed bread.
• Never insert your fingers into the bread slots.
• Switch the toaster off at the power supply socket and unplug it.
• Allow the toaster to completely cool down.
• Carefully ease the bread out of the toaster being careful not to damage the
heating element.
• Always switch off, unplug and allow the toaster to cool down before moving, cleaning
or storing. Never immerse the toaster or power cord and plug in water or any other
liquid.
• Clean the outside of your toaster with a damp cloth then dry thoroughly.
• Never use harsh, abrasive or caustic cleaners.
• Crumb removal
• It is important that crumbs are not allowed to build up inside your toaster. Excess
crumbs are unhygienic and could catch fire.
• Crumbs can be removed by sliding the crumb tray out from the bottom of your
toaster.
• You can then tip the crumbs out. Always make sure that your toaster has completely
cooled down and is disconnected from the power supply before removing crumbs.
• Never use your toaster without the crumb tray fitted. Always replace the crumb tray
before using your toaster.

Toasting tips

Care and Cleaning Instructions

4