Makita PC5010C Manuel D'instruction page 14

1
2
3
► 1. Lock nut 2. Abrasive cut-off wheel / diamond
wheel 3. Inner flange 4. Wheel guard for abrasive
cut-off wheel / diamond wheel
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner flange varies by wheel type and thickness.
Refer to the following figures.
When installing the abrasive cut-off wheel:
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4
mm (5/32")) 3. Abrasive cut-off wheel (4 mm (5/32")
or thicker) 4. Inner flange
When installing the diamond wheel:
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32")) 3. Diamond wheel (4 mm (5/32") or thicker)
4. Inner flange
1 1
2 3
4 4
1 1
2 3
4 4
MAINTENANCE
CAUTION:
switched off and unplugged before attempting to
perform inspection or maintenance.
4
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Replacing dust cover brush
Worn brushes can be replaced. To remove the brushes,
pull them off by using slotted driver or other appropriate
tool.
► 1. Brush (large) 2. Brush (small)
Inserting new brushes into retaining grooves by pushing
down from above.
At this time, ensure that brushes are fully hooked onto
hooks on outer edges of grooves.
14 ENGLISH
Always be sure that the tool is
Never use gasoline, benzine, thinner,
2
1