Petromax Atago Mode D'emploi page 7

Figure 1
1. Grasp the handle in the centre.
2. Carefully pull the handle upwards (see
Figure 2) to extend the inner cylinder and
the three legs.
3. Once the Petromax Atago is ready for use,
place it carefully on a steady, heat-resistant
and even surface.
Figure 2
PREPARATION & USE
Do not use more than 30 briquettes
at once. Do not use grill-lighter fluids.
In no time, the Petromax Atago is ready for
cooking and barbecue purposes. Only use solid
grill lighters. Grill lighter fluids are rather not
suited, for the Atago burns solid grill lighters
efficiently thanks to the stack effect. Read and
follow these instructions to prepare the Atago
and to burn the charcoal briquettes most effi-
ciently.
1. Place the necessary amount of Petromax
Zunder (or another solid grill lighter) on the
bottom of the Petromax Atago and spread it
out evenly. You will need approximately one
package of Petromax Zunder for 25 char-
coal briquettes.
2. Use the air regulation lever to allow
maximum airflow.
3. Place the charcoal grate in its intended place
in the Atago. Never use the Petromax
Atago without the charcoal grate!
4. Then use charcoal tongs to place the desired
number of briquettes (max. 30 briquet-
tes) on the charcoal grate. Spread out the
briquettes over the Zunder, so that they
burn evenly.
5. Carefully light the Petromax Zunder.
6. Wait until the briquettes are completely
incandescent and covered with the typical
grey ash. This procedure may take up to 30
minutes depending on the amount and
quality of the briquettes.
7