Inserting Bits - Parkside PASD 4 A1 Traduction Des Instructions D'origine

Stop charging
♦ Disconnect the charger
♦ Disconnect the USB-C plug of the charging cable
charging socket

Inserting bits

WARNING!
► The insulated bits
before each use. The insulation must be checked for possible
damage, among other things.
► If there is any doubt about the safety of the isolated bits, they
should either be scrapped or examined by an expert.
► Only the supplied insulated bits are suitable for work
under a voltage of 1000 V.
Only these insulated bits and the cordless screwdriver
PASD 4 A1 in combination may be used by a qualified
electrician to work on live components!
► Never use other, non-approved bits to work on live
components! This can result in the following hazards:
–
Risk of electrocution for the user;
–
Risk of exposure of the built-in battery to external voltages
(fire, explosion);
–
Risk of external voltage effects and potential transfer
(voltage) at the charging socket
potential transfer via the connected USB cable to other
sources;
–
The insulated bits must not be used with other manual drive
parts (e.g. handles, ratchet, etc.).
│ GB │ IE
■ 42
from the mains power supply.
.
must be visually checked by the user
from the
and possibly further
PASD 4 A1