Installing & Cleaning Reusable Cloth Filter; Installing & Cleaning Foam Wet Filter - ArmorAll AA155 Manuel D'utilisation

INSTALLING & CLEANING REUSABLE CLOTH FILTER
Installing Reusable Cloth Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position.
3. Slide reusable cloth filter down over the filter cage making sure the cage is completely covered. ( fig. 2 &
3)
4. Replace and lock the power head on to the collection tank.
Removing and Cleaning Reusable Cloth Filter
1. With the removed power head in an upside down position, carefully remove the reusable cloth filter
from the filter cage. (fig. 4) Clean the filter by gently tapping or brushing dirt off. Cleaning should not
be done indoors in living areas.
2. Use a mild soap and water solution to wash reusable cloth filter and rinse with clean water. (fig. 5)
3. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
INSTALLING & CLEANING FOAM WET FILTER
Installing Foam Wet Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter.
3. Carefully slide foam
(fig. 2 & 3)
4. Place the power head back onto the collection tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside down position, carefully remove foam wet filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
wet filter down over the filter cage making sure the
10
cage is completely covered.