Connecting The Motor - SCHOLTES HL 997 Manuel D'utilisation

Connecting the motor

For the HLS 998 model
! The assembly comes without a motor and therefore
must be connected to a motor (accessory purchased
separately) located outside of the appliance itself. The
electrical connection must be made using the
appropriate terminals.
! Only use 4-speed Scholtès motor.
Connecting the exhaust duct to the
external motor
The external motor unit must be installed in a suitable
location in compliance with current safety regulations.
The motor and the assembly must be connected using
an exhaust duct with the correct diameter (Ø 150 mm).
To insure that the hood operates efficiently, keep in
mind that ventilation becomes less efficient the longer
the exhaust duct which connects the assembly to the
motor.
The exhaust duct must not exceed 7 meters in length.
The materials (the duct and the clamp) must be
provided by the installer.
Electrical connection for external motor
•
Check the position of electrical connection
compartment B situated over the hood.
•
Remove the screws to open the B compartment
cover.
•
Open the cable block by removing the L screws.
•
To connect the hood to the motor use an
harmonized omnipolar interconnection cable (HAR)
type H05 VV-F (6 x 0,75mm
•
Connect the terminals of the cable coming from the
motor to the terminal board situated on the B
compartment on the hood.
•
Close cable block L again (this should act to block
both the cable coming from the hood and the
electric connecting cable of the external motor).
•
Close cover B.
•
Carry out the electrical connection of the hood to
the power.
2
).
External Motor
Unit
harmonized
omnipolar
interconnection
cable (HAR) type
H05 VV-F (6 x
Duct
2
0,75mm ).
blue
white
red
grey
black
yellow/green
blue
white
red
grey
black
yellow/green
15
GB