Choosing The Right Detergent; Washer Maintenance And Care; Water Inlet Hoses; Washer Care - Whirlpool W11354658 Manuel De L'utilisateur

CHOOSING THE RIGHT
DETERGENT
Use only High Efficiency detergents. The package will be marked
"HE" or "High Efficiency." Low-water washing creates excessive
sudsing with a non-HE detergent. Using non-HE detergent will
likely result in longer cycle times and reduced rinsing
performance. It may also result in component malfunction and,
over time, buildup of mold or mildew. HE detergents should be
low-sudsing and quick-dispersing to produce the right amount of
suds for the best performance. They should hold soil in
suspension so it is not redeposited onto clean clothes. Not all
detergents labeled as High Efficiency are identical in formulation
and their ability to reduce suds. For example, natural, organic, or
homemade HE detergents may generate a high level of suds.
Always follow the detergent manufacturer's instructions to
determine the amount of detergent to use. Do not go over the Max
Line on the dispenser. See Quick Start Guide for more
information.
WASHER MAINTENANCE AND
CARE

Water Inlet Hoses

Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses:
� Mark the date of replacement on the label with a permanent
marker.
� Check that the old washers are not stuck on the washer inlet
valves.
� Use new washers in the new inlet hoses to ensure a proper
seal.
NOTE: This washer may not include inlet hoses. See the
Installation Instructions for more information.

Washer Care

Recommendations to help keep your washer
clean and performing at its best
1. Always use High Efficiency (HE) detergents and follow the HE
detergent manufacturer's instructions regarding the amount of
HE detergent to use. Never use more than the recommended
amount because that may increase the rate at which
detergent and soil residue accumulate inside your washer,
which in turn may result in undesirable odor.
2. Use warm and hot wash water settings sometimes (not
exclusively cold water washes), because they do a better job
of controlling the rate at which soils and detergent
accumulate.
3. Always leave the washer lid open between uses to help dry
out the washer and prevent the buildup of odor-causing
residue.
Cleaning your top-loading washer
Read these instructions completely before beginning the routine
cleaning processes recommended below. This Washer
Maintenance Procedure should be performed, at a minimum,
once per month or every 30 wash cycles, whichever occurs
sooner, to control the rate at which soils and detergent may
otherwise accumulate in your washer.
Cleaning the inside of the washer
To keep your washer odor-free, follow the usage instructions
provided above and use this recommended monthly cleaning
procedure:
Recommended cycle for cleaning the asher
Some models have a "Clean Washer" cycle that uses higher water
volumes in combination with affresh
chlorine bleach to clean the inside of the washer.
If your model does not have a "Clean Washer" cycle, refer to the
online Cycle Guide for the optimal cycle for cleaning the inside of
the washer. Use this cycle with affresh
chlorine bleach as described below.
Description of Clean Washer with affresh
operation:
1. This cycle will fill to a washer level high than in normal wash
cycles to provide rinsing than in normal wash cycles to provide
rinsing at a level above the water line for normal wash.
2. During this cycle, there will be some agitation and spinning to
increase the removal of soils.
After this cycle is complete, leave the lid open to allow for better
ventilation and drying of the washer interior.
Begin procedure
1. Affresh ® washer cleaner cycle procedure (recommended
for best performance):
a. Open the washer lid and remove any clothing or items.
b. Place an affresh ® Washer Cleaner tablet in the bottom of
the washer basket.
c. Do not place an affresh
detergent dispenser.
d. Do not add any detergent or other chemical to the washer
when following this procedure.
e. Close the washer lid.
f. Select the cycle recommended for cleaning the inside of
the washer.
g. Press the Start button to start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must be
interrupted, press Power/Cancel. (For models with no Power/
Cancel button, press and hold Start/Pause for three seconds.)
After the cycle has stopped, run a Rinse & Spin cycle to rinse
cleaner from washer.
2. Chlorine bleach procedure (alternative):
a. Open the washer lid and remove any clothing or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach to the bleach
compartment.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer damage over
time.
c. Close the washer lid.
d. Do not add any detergent or other chemical to the washer
when following this procedure.
e. Select the cycle recommended for cleaning the inside of
the washer.
f. Press the Start button to start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must be
interrupted, press Power/Cancel. (For models with no Power/
Cancel button, press and hold Start/Pause for three seconds.)
After the cycle has stopped, run a Rinse & Spin cycle to rinse
cleaner from washer.
Cleaning the dispensers
After a period of using your washer, you may find some residue
buildup in the washer's dispensers.
IMPORTANT: Dispensers are not dishwasher-safe.
® Washer Cleaner or liquid
® Washer Cleaner or liquid
® cycle
® Washer Cleaner tablet in the
3