Makita DLM380 Manuel D'instruction page 10

2
014496
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Malfunction status
Mower does not start.
Motor stops running after
a little use.
It does not reach maximum
RPM.
Cutting tool does not rotate:
stop the machine immediately!
Abnormal vibration:
stop the machine immediately!
014546
1. Handle
1
2. Clamping nut
Cause
Two battery cartridges are not
installed.
Battery problem (under voltage)
The lock key is not inserted.
Battery's charge level is low.
Cutting height set is too low.
Battery cartridge is installed
improperly.
Battery power is dropping.
The drive system does
not work correctly.
Foreign object such as a branch is
jammed near the blade.
The drive system does not work
correctly.
Blade is imbalanced, excessively
or unevenly worn.
10
TROUBLE SHOOTING
Before asking for repairs, first, conduct your own
inspection. If you find a problem that is not explained in
the manual, do not attempt to dismantle the tool.
Instead, ask Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Install the charged battery
cartridges.
Recharge the battery cartridge. If
recharging is not effective, replace
battery cartridge.
Insert the lock key.
Recharge the battery cartridge. If
recharging is not effective, replace
battery cartridge.
Raise the height.
Install the battery cartridge as
described in this manual.
Recharge the battery cartridge. If
recharging is not effective, replace
battery cartridge.
Ask your local authorized service
center for repair.
Remove the foreign object.
Ask your local authorized service
center for repair.
Replace the blade.
Action