Environmental Protection; Explanation Of Symbols - F.F. Group CDD-BL 20V PRO Notice Originale

8 | English
tered edges on the back of the hole.
DRILLING METAL (41316-41317)
For maximum performance, use HSS drill bits for
ƒ
metal drilling.
Set the tool to the drill mode. Mark off the centre of
ƒ
the hole using a centre punch.
Use a suitable lubricant for the material you are
ƒ
working on.
Begin drilling at a very low speed to prevent the bit
ƒ
from slipping off the starting point.
Always clamp sheet metal. Support thin metal with
ƒ
a block of wood to avoid distorting it.
DRILLING MASONRY (41317)
Start drilling at a low speed to prevent the drill bit
from wandering. Once penetration is achieved, fully
depress the trigger to achive maximum speed and
hammer power.
MAINTENANCE
1. To prevent accidents, always disconnect the battery
from the tool. Before cleaning or performing any
maintenance the tool may be cleaned most eff ec-
tively using compressed air. Always wear safety gog-
gles when using compressed air. If compressed air is
not available, use a brush to remove dust and chips
from the tool.
2. Motor ventilation vents and switch levers must be
kept clean and free of foreign matter. Do not at-
tempt to clean by inserting pointed objects through
openings.
3. Never use any caustic agents to clean plastic parts.
Such as: gasoline, carbon tetrachloride, chlorinated
cleaning solvents, ammonia and household cleaners
containing ammonia. Do not use any of these to
clean the tool.
4. Keep the machine clean all the time.
5. Clean the housing only with a damp cloth. Do not
use any solvents! Dry thoroughly afterwards.
CAUTION: Do not use cleaning agents to clean the
plastic parts of the tool. A mild detergent on a damp
cloth is recommended. Water must never come into
contact with the tool.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly
recycling. The plastic components are labeled
for categorized recycling.

EXPLANATION OF SYMBOLS

Double insulation
For indoor use only. Do not expose to
rain.
Wear eye protection.
Damage to lungs if an eff ective dust mask
is not worn.
Wear protective gloves
Damage to hearing if eff ective hearing
protection is not worn.
To reduce the risk of injury, the user must
read and understand this manual before
using this product.
Important!
Conforms to relevant safety standards
Li-ion battery must be recycled or dis-
posed of properly
Protect the battery against heat and fi re
Protect the battery against temperatures
above 45 C
o
GUARANTEE
This product is warranted in accordance with the
legal/country specifi c regulations, eff ective from
the date of purchase by the fi rst user. Damage
attributable to normal wear and tear, overload or
improper handling will be excluded from the guar-
antee. In case of a claim, please send the machine,
completely assembled, to your dealer or the ser-
vice Centre for electric power tools.
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
ƒ
product is in conformity with the following standards
or standardized documents: EN 62321, EN 55014-1,
EN 55014-2, EN 60745-1, EN 60745-2-1, EN 60745-2-
2 in accordance with the provisions of the directives
2011/65/EU, 2014/30/EU, 2006/42/EC.
Technical File at:
ƒ
FF GROUP TOOL INDUSTRIES S.A., FF GROUP TOOL INDUSTRIES S.A.,
19300, Aspropyrgos - Greece 19300, Aspropyrgos - Greece
Loudovikos Tsirigiotis
Operations & Engineering
FF GROUP TOOL INDUSTRIES S.A., 19300
Aspropyrgos - Greece. 5/03/2018