Working Instructions; Maintenance And Cleaning - F.F. Group RH 2-26 PLUS Notice Originale

RH 2-26 PLUS | RH 2-26 FC PLUS
Switching off: Release the on- off switch (10)
f
To lock the pressed on/off switch (10), push
f
the lock-on button (9) upward. To switch off
the power tool. Release the on/off switch (10)
or when it is locked with the lock-on button (9),
briefly press the on/off switch (10) and then re-
lease it.

WORKING INSTRUCTIONS

OVERLOAD CLUTCH
If the drill bit becomes jammed or caught, the drive
f
to the drill spindle is interrupted.
Because of the forces that occur as a result, al-
ƒ
ways hold the machine with both hands and take
a secure stance. The machine should be used only
with an auxiliary handle.
Auxiliary Handle (6). You will be able to obtain a
f
safe position when working by rotating the handle
attachment. Loosen and turn the handle attachment
in an anticlockwise direction.
Depth Stop (5). Loosen the winged screw on the
f
auxiliary handle (6). Adjust the drilling depth on the
depth stop (5). Retighten the winged screw.
REVERSING SWITCH ACTION
The direction of the machine can be changed by
reverse switch. Turn the lever into A, then clock-
wise rotation. Turn the lever into B, then counter-
clockwise rotation.
CAUTION:
Check the rotation direction before working.
ƒ
Before changing the lever direction, make sure
ƒ
the tool already stop working. If not, the machine
may damaged.
When for counterclockwise working, turn the le-
ƒ
ver at the left side and be sure that the lock shall
not be pressed.
WOOD&METAL WORKING (B, C)
Turn the knob to
It's right for drilling the hole not more than 13mm
for metal and 32mm for wood.
CAUTION:
1. Please don't turn the knob to rotary hammer
position when you use chuck for drilling work
because it will damage the drill bit.
2. Please don't force the tool by heavy strength.
It can't make the work quicker and may dam-
age the drill bit.
3. Please hold the tool tightly and be careful
when you finish drilling the hole.
4. You can release the drill bit by reverse switch
once the drill bit gets stuck in the hole. And
be careful the tool may release quickly if can't
hold it well.
DRILL CHUCK – SDS PLUS CHUCK (45 333)
Press the sliding collar (4), insert the drill chuck
or SDS plus chuck into the spindle's hole. Then re-
lease the sliding collar. It is ok when chuck can't be
pulled out, otherwise the chuck need reassemble.
, and install the drill chuck.
OPERATING MODES (A)
Warning!
Change the operating mode only when
the machine is switched off! Otherwise,
the machine can be damaged
Please trigger the release button of the operational
mode selection switch slightly.
1. Drill mode:
Turn the mode
selector switch 7
to direction.
2. Hammer drill
mode:
Turn the mode
selector switch 7
to direction.
3. Chisel mode
Turn the mode
selector switch 7
to direction.
4. Changing the
chiseling posi-
tion
The chisel can be
locked in 8 posi-
tions. In this man-
ner, the optimum
working position
can be set for
each application.
Insert the chisel
into the tool
holder. Adjust the
chiseling position
to your desired
angle, then switch
to chisel mode to
apply.

MAINTENANCE AND CLEANING

Before any work on the machine itself, pull the
mains plug. For safe and proper working, always
keep the machine and the ventilation slots clean.
Clean the tool mount daily.
English | 9
www.ffgroup-tools.com