Setting Time And Date; Setting The Alarm - Medisana MTX Connect Mode D'emploi

GB
3 Getting Started
3.3
Setting time
and date
3.4

Setting the alarm

24
pressure monitor. If the blood pressure monitor is no longer being used, first
remove the connector from the blood pressure monitor and then pull the mains
adaptor out of the mains socket. Doing this means that the date and time will
not have to be reset each time.
1. You can set the date and time by pressing down the TIMER button
several seconds until
2. The selected user memory appears on the display together with the
flashing year.
- Press the TIMER button
to flash.
- Press the TIMER button
- Press the TIMER button
flash.
- Press the TIMER button
- You can set the current date and time (year, month, day, hours and
minutes) by pressing the MEMO button
time with the TIMER button
shown twice each in succession before the device returns to standby
mode. In standby mode, the time is displayed permanently.
NOTE
If you do not wish to set the time or you want to take a
measurement immediately, exit the time setting mode by
pressing the START button
Your MEDISANA MTX Connect blood pressure meter is equipped with an
alarm function, with which the two users can set two alarm times each, in
order to take medication are regular intervals, for example.
Make sure that the device is in standby mode and your own user memory
has been selected.
1. Press the TIMERbutton
both buttons until the alarm symbol
2. Release both buttons. " 1 " flashes at the bottom right of the display for
Alarm 1. You can use the MEMO button
3. Press the TIMER button
Use the MEMO button
4. Press the TIMER button
button to switch between alarm on (
your entries, press the TIMER button
appears on the display.
again to display the date; the month starts
again and the day starts to flash.
again to display the time. The hour starts to
again and the minutes start to flash.
and confirm the date and
. Then the date and time you set are
.
followed by the MEMO button
appears on the display.
to select Alarm 1 or Alarm 2.
. The display for entering the alarm time flashes.
to enter the alarm time.
and the alarm symbol flashes. Use the MEMO
) and alarm off (
.
for
. Hold down
) . To confirm