Cleaning And Maintenance; Technical Specifications - Toolland TM91001 Mode D'emploi

• Push the trigger-locking lever with the middle finger.
• For another nail/staple you must completely lift up the machine from the workplace.
5. Clearing a Jammed Fastener
Before removing a blocked nail/staple you must switch off the machine and disconnect the air supply.
•
Remove the nail/staple stick from the magazine.
•
Remove the blocked nail/staple. Use a pincer if necessary.
•
• Lubricate the shot duct.
• Place a new nail/staple stick in the magazine.
6.

Cleaning and Maintenance

Disconnect the air supply from the tool before lubricating.
•
Your tool requires lubrication before you use it for the first time.
•
Wipe off excessive oil at the exhaust. Excessive oil will damage O-rings of the tool. If in-line oilier is used,
•
manual lubricating through the air inlet is not required on a daily basis.
Turn the tool so the inlet is facing up hand put one drop of high speed oil. Never use detergent oil or
•
additives. Operate the tool briefly after adding oil.
7.

Technical Specifications

max. operating pressure
nail size
staple size
capacity
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.toolland.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 02 – 14/04/2015
TM91001
7 bar
10-32 mm
6-32 mm
100 pcs
1.25 kg
3 ©Velleman nv